Nico 240V LED Surface/Recessed Light

A simple solution to create a stunning look. The recess/surface light is very versatile, it can be either recess or surface mounted under a cabinet to illuminate the worktop or used inside a wall unit. Use in a glass fronted cabinet to create a subtle mood light or use with a door sensor inside a wall unit so the light comes on as the door opens and switches off as the door closes.

Key Points

• > Surface Light Source (SLS) products are LED fittings with no visible LED points.
• > This fitting runs at 240V so no driver is required.
• > Extremely simple to install if you use the 6 way distribution block. Simply connect up to 6 of the Nico fittings into the ports on the distributor block and connect this directly to the mains supply (13A plug pre-wired to the SE211570).
• > When using the distribution block anyone can install these fittings – no need for Part P as it is all plug and play.
• > Use as task lighting under cabinets or to illuminate cabinet interiors in glass fronted wall units.
• > Spacer included, fitting can be surface mounted or recessed.
• > Extremely long lamp life. This fitting will more than likely outlive your kitchen.
• > A much smaller and neater fitting than GX53 with a connector small enough to fit through an 8mm hole.

Specification

Wattage: 3W
Voltage: 240V
Kelvin: Cool White (5000k) / Warm White (3000k)
Lumen Output: Cool White (180lm) / Warm White (170lm)
Beam Angle: 110°
Life span: 15 years
Cable Length: 1.5 metres
Finish: Stainless Steel
Dimmable: Yes, with Sensio Dimmers